Thread Tools

Display Modes

Pro_Wanna_Be · 12-01-2006, 06:38 AM

Just wondering whether or not .335 shaft is bigger or smaller than a .350 shaft?

Golfbum · 12-01-2006, 08:16 AM

Quote:

Originally Posted by Pro_Wanna_Be

Just wondering whether or not .335 shaft is bigger or smaller than a .350 shaft?

.350 tip is bigger.
However if you have a driver that takes a .350 shaft and you would like to shaft it with a .335 tip shaft it can be done. Shaft shims are used to make up the difference in tip size. Club repair people can do this with no problem.

Pro_Wanna_Be · 12-01-2006, 11:45 AM

Just so that I can get a bearing on the shaft size. Standard irons use what size shaft?

tourspec33 · 12-04-2006, 01:46 AM

Irons have 2 sizes as well. Most commonly used are parrallel tip .370", which is larger than the taper tip shafts .355" that are "butt trim ONLY!" You just need to measure the inside of the clubs hosel with calipers and you should be able to figure out what you need. Let me know!

tourspec33 · 12-04-2006, 01:47 AM

Tell me what irons and i could probably tell you what shaft size it takes.

Pro_Wanna_Be · 12-04-2006, 07:02 AM

The iron heads that i'm looking at are Taylormade Firesole.

tourspec33 · 12-05-2006, 01:21 AM

The Taylormade Firesole is a .370" parallel tip.

Pro_Wanna_Be · 12-05-2006, 06:59 AM

Holly crap they were not even close telling me that they were .350.

tourspec33 · 12-05-2006, 12:20 PM

Who told you that??? Irons are either .355" taper tip or .370" parallel tip
TaylorMade Firesole Woods would be .350" tip.

Pro_Wanna_Be · 12-05-2006, 02:44 PM

Right on. Thanks for your reply. I'm just going by what was written in the description. They said .350. Likely they was looking at the hosel of wood heads.